Topic: brain reduction machine  (Read 3290 times)

0 Members and 1 Guest are viewing this topic.

brain reduction machine
« on: June 26, 2014, 11:21:16 AM »
A man went to a doctor, and said he wanted to be able to get a job atthe local Post Office, but unfortunately he was too smart.The doctor asked him his IQ, and when he gavea three-digit reply,the doctor told him that the procedure would have to involve theremoval of over half of his brain.The man insisted, and since the doctor just happened to have a brandnew laser device which could zap just the right portions of braintissue, so the operation was planned.The laser was hooked up to a computer which could monitor the man'sdeclining IQ on a nice bright LED display.  The doctor threw theswitch and the numbers began ticking off . . . 95, 94, 93 . . .Suddenly the phone rang.  It was the doctor's wife.  They gabbed fora few minutes, the doctor forgetting completely about his patient.When he hung up, he suddenly realized, and ran into the operatingroom, only to see the meter ticking down 6, 5, 4 . . .He ran to the machine and threw the on/off switch, just as the laserwas about to wipe out the last remnant of brain.  "Oh my!" exclaimedthe doctor, "What have I done?  Speak to me! Say anything!"The man looked at him and said, "I, Al Gore, announce my candidacyfor President of the United States . . ."

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
3837 Views
Last post September 06, 2012, 09:56:07 PM
by ayodeji
1 Replies
3126 Views
Last post August 23, 2013, 03:16:01 PM
by ayo2
0 Replies
1722 Views
Last post February 24, 2014, 08:07:40 PM
by flukky01
0 Replies
1297 Views
Last post January 04, 2015, 08:58:59 AM
by olutee
0 Replies
1068 Views
Last post November 17, 2017, 07:04:57 AM
by olutee
0 Replies
993 Views
Last post May 21, 2020, 07:01:08 PM
by NaijaPilot
0 Replies
678 Views
Last post July 10, 2020, 07:03:13 AM
by flukky-2
0 Replies
628 Views
Last post January 14, 2022, 07:02:02 AM
by olutee
0 Replies
186 Views
Last post February 25, 2023, 07:06:00 PM
by PulseNG
0 Replies
133 Views
Last post February 06, 2024, 07:01:46 AM
by flukky-2