Topic: Man forgives wife who attempt to murder him because she was too good in bed  (Read 2898 times)

0 Members and 1 Guest are viewing this topic.

A businessman from Kangemi on Tuesday stunned a Kibera Court after he asked to withdraw an assault case against his wife who attempted to kill him by stabbing him and leaving him for dead.

Rodgers Ndenda, who was admitted in hospital gathered strength and showed up at the court when his wife, Naomi Kinyanjui, was just about to take a plea.

He told the Kibera magistrate, Jacintah Kwena, that he did not want to proceed with the case because he had forgiven his wife. His reasons being that the wife was good in bed and satisfied him to the fullest.

Ndenda's reason shocked those present in the court room with the magistrate asking the Kangemi based businessman if he was sure of his decision. Ndenda, who seemed to be in much pain, reiterated saying that he had forgiven his wife.

Kwena explained that the wife was a dangerous person who can kill adding that next time the husband wont' be lucky and asked Ndenda to think deeply about his decision but he said that he came to the decision after thoroughly thinking over it.

With that, the magistrate adjourned the case saying that he will decide after he receives a probation report.

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
1156 Views
Last post September 27, 2017, 07:04:20 PM
by olutee
0 Replies
1369 Views
Last post November 23, 2017, 07:03:02 AM
by thisday
0 Replies
797 Views
Last post November 26, 2017, 01:01:08 AM
by olutee
0 Replies
844 Views
Last post April 08, 2018, 01:01:32 AM
by sahara
0 Replies
790 Views
Last post April 08, 2018, 01:01:37 PM
by sahara
0 Replies
631 Views
Last post November 06, 2018, 01:01:43 PM
by thisday
0 Replies
627 Views
Last post July 01, 2019, 01:01:08 PM
by olutee
0 Replies
513 Views
Last post February 19, 2020, 01:14:35 AM
by clowntom
0 Replies
368 Views
Last post December 21, 2020, 07:00:49 PM
by flukky-1
0 Replies
188 Views
Last post February 11, 2023, 07:01:15 PM
by flukky-2